In Explosion-proof motor during use, stand by the cause of the problem is mainly manifested in its distortion, the distortion will have a direct impact on the functioning of the explosion-proof motor. So, what are the reasons for not making the cradle of deformed? Next to the small to give you describe:

　　The cradle of the deformed by design, manufacture of two factors:

　　1) Design: Not fully in accordance with the theory of structural mechanics design loads, such as the seat of the axial, radial ribs the size, shape and position of the design; the overall design of the 匀. For example, stand in the lower left after processing a valid department is too small.

　　2, the production of reasons: aging in place; the workpiece processing fashion card site and the load is uneven, processed, and release the card down, stand as a result of the reaction of the deformed. Handling a deformed, however this is a minor reason.

　　As a result of the explosion-proof motor is running the CPC is the phenomenon exists that often appear in a 一 speed, during start up, the fleeting. As a result, the deformation is not easy to be aware of. As a result of aging in place as a result of deformation and is not easy to be aware of. As a result of the welding stress is fully released and the need for a long period of time, it is processed, it is difficult to find, especially in the case of a short duration. This is also the typical pitfalls. The explosion-proof motor during the production process, it is important to note.